View 4810_372291.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

ARX4810 & 4810FP Universal Dual Transceivers for MIL-STD-1553
& MACAIR A3818, A5690, A5232 & A4905
Features
* World's smallest dual "Universal Transceiver" 0.3" X 1.2" Package * Dual transceiver meets military data bus requirements, MIL-STD-1553 and Macair specs * Low power dissipation at full output power * +5 / -15 Volt Power Supply Operation * Voltage source output for higher bus drive power * Monolithic construction using linear ASICs * Processed and screened to MIL-STD-883 specs * MIL-PRF-38534 Compliant Devices Available * DESC SMD (Standard Military Drawing)
CIRCUIT TECHNOLOGY
www.aeroflex.com
General Description
The Aeroflex Circuit Technology Models ARX4810 and ARX4810FP are new generation monolithic transceivers which provide full compliance with MIL-STD-1553 and Macair data bus requirements in the smallest packages with low power consumption and two power supply operation. The dual channel Model ARX4810 and Model ARX4810FP perform the front-end analog function of inputting and outputting data through a transformer to a MIL-STD-1553 or Macair data bus. Design of these transceivers reflects particular attention to active filter performance.This results in low bit and word error rate with superior waveform purity and minimal zero crossover distortion. Efficient transmitter electrical and thermal design provides low internal power dissipation and heat rise at high as well as low duty cycles. Each channel of the dual transceiver is completely separate from the other and fully independent. This includes power leads as well as signal lines. Hence, each channel may be connected to a different data bus with no interaction.
X L E1 0 9 F8 7 R O 4883 X A E R SAAU
ARX4810 Dual Universal Transceiver
TX/RX TX DATA IN TX DATA IN DRIVER SHAPING OUTPUT STAGE TX/RX
TX INHIBIT RX DATA OUT
+5 V -15 V to -12V GROUND
REFERENCE
COMP.
Transmitter
INPUT AMP ACTIVE FILTER COMP. RX DATA OUT
STROBE
Block Diagram (without transformer), 1/2 of unit shown
The Transmitter section accepts bi-phase TTL data at the input and when coupled to the data bus with a 1:1 transformer, isolated on the data bus side with two 52.5 Ohm fault isolation resistors, and loaded by two
eroflex Circuit Technology - Data Bus Modules For The Future (c) SCD4810 REV B 8/12/98
70 Ohm terminations plus additional receivers, the data bus signal produced is 7.5 volts nominal P-P at A-A'. (See Figure 5) When both DATA and DATA inputs are held low or high, the transmitter output becomes a high impedance and is "removed" from the line. In addition, an overriding "INHIBIT input provides for the removal of the transmitter output from the line. A logic "1" applied to the "INHIBIT" takes priority over the condition of the data inputs and disables the transmitter. (See Transmitter Logic Waveform, Figure 1.) The transceiver utilizes an active filter to suppress harmonics above
1 MHz to meet Macair specifications A-3818, A-4905, A-5232 and A-5690. The Transmitter may be safely operated at 100% duty cyclefor an indefinite period into a short circuited, the 1553 or Macair bus.
The pre-set internal thresholds will detect data bus signals exceeding 1.150 Volts P-P and reject signals less than 0.6 volts P-P when used with a 1:1 turns ratio transformer. (See Figure 5 for transformer data and typical connection.)
Receiver
The Receiver section accepts bi-phase differential data at the input and produces two TTL signals at the output. The outputs are DATA and DATA, and represent positive and negative excursions of the input beyond a pre-determined threshold.(See Receiver Logic Waveform Figure 2).
Figure 1 - Transmitter Logic Waveforms
DATA IN
DATA IN
INHIBIT
LINE TO LINE OUTPUT NOTES: 1. DATA and DATA inputs must be complementary waveforms or 50% duty cycle average, with no delays between them. 2. DATA and DATA must be in the same state during off time (both high or low).
Figure 2 - Receiver Logic Waveforms
LINE TO LINE INPUT
DATA OUT
DATA OUT
Note overlap
NOTE: Waveforms shown are for normally low devices. For normally high receiver output level devices,the receiver outputs are swapped as shown by the dashed lines. ,
Aeroflex Circuit Technology
2
SCD4810 REV B 8/12/98
Plainview NY (516) 694-6700
Absolute Maximum Ratings
Operating case temperature Storage case temperature Negative Power supply Voltage Positive Power Supply Voltage Receiver differential input Receiver input voltage (common mode) Driver peak output current Total package power dissipation over the full operating case temperature rise Maximum junction to case temperature rise for the hottest device Thermal resistance for the hottest device, junction to bottom of case -55C to +125C -65C to +150 C -15 V P.S. to -18V MAX -0.3 V to +5.5 V 10 V 5 V 300 mA 4 Watts
(Note. Normal operation conditions require one transmitter on and the other off at any given time, with a maximum dissipation of 3.2 watts.)
6 C 3 C/W
Electrical Characteristics, Driver Section
Input Characteristics, TX DATA in or TX DATA in Parameter Condition
"0" Input Current "1" Input Current "0" Input Voltage "1" Input Voltage VIN = 0.4 V VIN = 2.7 V
Symbol
IILD IIHD VIHD VIHD
Min
Typ
-0.25 1
Max
-0.4 40 0.7
Unit
mA A V V
2.0
Inhibit Characteristics
"0" Input Current "1" Input Current "0" Input Voltage "1" Input Voltage Delay from TX inhibit,(01) to inhibited output Delay from TX inhibit, (10) to active output Differential output noise, inhibit mode Differential output impedance (inhibited) Note 2 Note 1 Note 1 VIN = 0.4V VIN = 2.7V IILI IIHI VILI VIHI 2 240 210 2 7K 350 350 10 -0.25 1.0 -0.4 40 0.7 mA A V V nS nS mV p-p
tDXOFF tDXON
VNOI ZOI
Note 1. Characteristics guaranteed by design, not production tested .
Output Characteristics
Differential output level Rise and fall times (10% to 90% of p-p output) Output offset at point A-A' on Fig 5., 2.5 S after midpoint crossing of the parity bit of the last word of a 660S message Delay from 50% point of TX DATA or TX DATA input to zero crossing of differential signal RL = 35 RL = 35 VO tR 6 200 6.8 240 7.7 300 V p-p nS
VOS
90
mV peak
Note 1
tDTX
260
350
nS
Note 2. Measured at 1MHz from bus side of transformer after contribution from transformer is accounted for.
Aeroflex Circuit Technology
3
SCD4810 REV B 8/12/98
Plainview NY (516) 694-6700
Electrical Characteristics, Receiver Section
Parameter
Differential Input Impedance Differential Voltage Range Input Common Mode Voltage Range Common Mode Rejection Ratio Note 3 Note 1 Note 1
Condition
f = 1MHz
Sym
ZIN VIDR VICR CMRR
Min
20K
Typ
Max
4
Unit
V peak V peak dB
2.5 40
Strobe Characteristics (Logic "O" inhibits output) if not used, a 1K pullup to 5 V is recommended
"0" Input Current "1" Input Current "0" Input Voltage "1" Input Voltage Strobe Delay (turn-on or turn-off) Note 1 VS = 0.4 V Vs = 2.7V IIL IIH VIL VIH tSD 2.0 10 78 -0.25 1 -0.4 +40 0.7 mA A V V nS
Threshold Characteristics (Sinewave input )
Input Threshold Voltage (referred to the bus) "1" State "0" State Delay, (average) from differential input zero crossings to RX DATA and RX DATA output 50% points 100KHz-1MHz VTH 0.60 0.8 1.15 VP-P
Output Characteristics, RX DATA and RX DATA
IOH = -0.4 mA IOL = 4 mA VOH VOL 2.5 3.4 0.3 280 0.5 450 V V nS
tDRX
Power Data
Maximum Currents, per channel (Power supplies used are -15V, and +5V) Duty Cycle -V +V and Logic
Transmitter Standby 25% duty cycle, Note 1 50% duty cycle 100% duty cycle, Note 1 42 mA 85mA 105 mA 140 mA 48 mA 90 mA 110 mA 145 mA
Power supply Voltages
-V Logic and +V -14.25 Volts to -15.75 Volts 4.5 Volts to 5.5 Volts
Note 3. Measured at the bus side of the transformer, including the contribution from the transformer. Note 4. Vcc= 5 Volts 0.1 V, for all measurements unless otherwise specified. Note 5. Specifications apply over the case temperature range of -55C to +125C unless otherwise specfied. Note 6. All typical values are measured at +25C Note 7. A 1uf, 10 Volt capacitor is required on the TX/RX terminal for each transceiver as shown in Figure 5. A Sprague 194D type (.05" W x .10" L x .05" H ) is suggested.
Aeroflex Circuit Technology
4
SCD4810 REV B 8/12/98
Plainview NY (516) 694-6700
Figure 3 - Transmitter (TX) Output Wave form
tf* 90%
Figure 4 - Transmitter (TX) Output offset
LAST BIT
Magnified View
OUTPUT OFFSET*
6.5V P-P MIN 8.5V P-P MAX
0 Volts
0 volts
OUTPUT OFFSET*
10%
2.5 sec
tr* *Offset measured at point A-A' in Fig 5 * Rise and fall times measured at point A-A' in Fig 5
Figure 5 - Typical Transformer connection
70 70
Figure 6 - Power Dissipation vs. Duty Cycle (per channel)
1uf, 10 V TX DATA OUT D.U.T B' TX DATA OUT
+
N1:N2 B
52.5 A Ctr tap A' 52.5 N1:N3 for stub coupling POWER DISSIPATION WATTS
4.0 3.5 3.0 2.5 2.0 1.5 1.0 0.5 TYPICAL
RX DATA IN RX DATA IN Transformer turns ratios: N1:N2 = 1:1 N1:N3 = 1:0.71 Use Aeroflex 25T1553-1
0 0
10
20
30
40
50
60
70
80
90 100
DUTY CYCLE, PERCENT
Configurations and Ordering Information
Model No.
ARX4810 ARX4810-201-1 ARX4810-201-2 ARX4810-201-3 ARX4810-203-1 ARX4810-203-2 ARX4810-203-3 ARX4811 ARX4811-2
Aeroflex Circuit Technology
DESC No.
5962-TBA 5962-9550501HXC 5962-9550501HXA
5962-9550501HXA or C
Receiver Data level
Normally High Normally High Normally High Normally High Normally High Normally High Normally High Normally Low Normally Low
5
Case
Plug-In Flat Pkg (.175 Lead) Flat Pkg (.175 Lead) Flat Pkg (.175 Lead) Flat Pkg (.300 Lead) Flat Pkg (.300 Lead) Flat Pkg (.300 Lead) Plug-In Flat Package
SCD4810 REV B 8/12/98
Configuration
Dual Dual Dual Dual Dual Dual Dual Dual Dual
Plainview NY (516) 694-6700
5962-9550501HYC 5962-9550501HYA
5962-9550501HYA or C
5962-TBA 5962-TBA
CIRCUIT TECHNOLOGY
Package Dimensions and Pin Outs
Flat Package
1.200 MAX 1.000 10 Equal Spaces @.100 .140 MAX .065 .015 .030 .010
Pin Numbers & Functions
Pin # 1 2 Function INHIBIT TX DATA IN TX DATA IN STROBE GROUND RX DATA OUT RX DATA OUT TX / RX TX / RX -15V +5V INHIBIT TX DATA IN TX DATA IN STROBE GROUND RX DATA OUT RX DATA OUT TX / RX TX / RX -15V +5V Channel A A A A A B B B B B B B B B B B A A A A A A
.310 MAX .175 or .300 MIN MIN .040 .018 .002 .010 .002 TYP
3 4 5 6 7 8 9 10
DIP Package
1.200 MAX 1.000 10 Equal Spaces @.100 .170 MIN .140 MAX
11 12 13 14 15
.310 MAX
.300 .010
16 17 18 19 20
Notes 1. Dimensions shown are in inches
21 22
Specifications subject to change without notice.
Aeroflex Circuit Technology 35 South Service Road Plainview New York 11830
Aeroflex Circuit Technology
Telephone: (516) 694-6700 FAX: (516) 694-6715 Toll Free Inquiries: 1-(800) THE-1553
6
SCD4810 REV B 8/12/98 Plainview NY (516) 694-6700

▲Up To Search▲

Price & Availability of 4810

	To Download 4810 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .